outstanding matte black door knobs that you must have
Once done you will now see the inside of the wooden door and the part of the doorknob that goes through it. Push the opening and closing mechanism on the front of the door and at the same time pull the remaining piece of the door knob from the outside it will slide out easily leaving a hole that goes through the door. Once this is done take the opening and closing mechanism and slide it out the front of the door too. Now you have to reverse the process place the opening and closing mechanism through the front of the door make sure the flat side of the mechanism looks to the side to which the door opens.
When door knob operates properly right carefully tightening the screws on your knob and also the latch assembly. At this time install the strike plate located on the door facing simply by being certain that it fits in the slot properly and installing the screws. Gradually examine the door and then make any necessary modifications. Straightforward work saving tip; Be sure you turn the latching mechanism as well as the latch the appropriate direction to begin with you can certainly insert them in backwards and then have to re-do your work.
Most Popular This Week
This is a simple guide to changing a damaged door knob at home. Carpenters charge by the hour and you also have to wait in line for them to have time to come and do what you need. Follow these simple instructions and you can get rid of that bothersome door knob that sticks or does not work anymore in a few minutes without breaking a sweat. This guide applies to standard knobs which are found all over your house if you want to change the front door knob well that is a different story which we will deal with on a separate article.
If the door opens outwards the flat side should look outwards too if it opens to the inside the flat side should look inwards. Now slip in the cylinder through the door knob hole while holding the opening and closing mechanism pushed in so that it fits into the space provided for it in the door knob cylinder. Find the two large screws and the metal cover that go on the inside and screw it in place. Make sure it is tight but not overly tight. Test this by tuning the outside knob the opening and closing mechanism should retract without resistance.